TC8000 - USB Debugging

When I switch to enable USB debugging in developer options I recieve a message:


ADB operation failed

ADB Debug mode is disabled by Admin.


Any suggestions?

Anonymous (not verified)
Hi,The two most likely


The two most likely reasons I can think of are:

1) USB ADB Usage has been set to 'Disable' (USB Manager - Zebra Technologies TechDocs ).  You can use StageNow to set this to 'Enable', Getting Started - Zebra Technologies TechDocs

2) Enterprise Home Screen is installed and USB debugging is disabled in the EHS configuration.  You can enable USB debugging if this is the case.


Vote up!
Vote down!

Points: 1

You voted ‘up’

Log in to post comments