Zebra GC420t How print on a label where lenght in under 9.6mm

Hello. I was try to print on a label where length in under 9.6mm to be more accurate i am using 8mm lenght (height) with 75mm width and gap 3mm. So when i am printing it start to print from middle and above. I have install the latest drivers and firmware i have calibrate it. And still nothing.

Attachments: 
Steven Si
If the printer has been

If the printer has been calibrated for the 8mmx75mm label already, then you need to take a look at the ZPL sent to the pritner. Most likely, the ZPL sent to the printer has instructed the printer to print from the middle above position. You need to tweak corresponding line(s) of the ZPL for the desired starting position.

Vote: 
Vote up!
Vote down!

Points: 0

You voted ‘up’


Log in to post comments