Hi,
First of all, sorry for my english.
I'm trying to design a label with ZebraDesigner and when I try to align centered a text I obtain different results and I don't know why. I have searched for info but I don't find the problem.
My label is 76mm x 51mm.
Example 1:
^FT3,48^A0N,28,28^FB600,1,0,C^FH\^FDTEXT TEXT TEXT TEXT TEXT TEXT^FS
Example 2:
^FT3,48^A0N,28,28^FB600,1,0,C^FH\^FDTEXT TEXT TEXT TEXT TEXT TEXT TEXT^FS
Example 3:
^FT3,48^A0N,28,28^FB600,1,0,C^FH\^FDTEXT TEXT TEXT TEXT TEXT TEXT TEXT TEXT TEXT^FS
I have attached a picture with my print results.
Example 1 is ok for me.
Example 2 shows me a blank space between last two words. Why is it autocompleting with blank spaces?
Example 3 shows me a blank space between last words. And last word is overlapping at the center. Same problem. It's autocompleting with blank spaces and last word doesn't fit. Without this blank space it should fit correctly.
Is it possible to avoid this blank space? And... why and when it appears? Becouse example 1 is ok.
Thank you!
Problem centering text |
1 Replies
Hi Jose
Looks like the problem is connected to your printer configuration.
I've just printed all 3 examples on my printer and they look good.
Width of my label is a little smaller than yours, so the latest word was cut, but we can see that there is no issues.
Have you tried to reset your printer to factory settings? If no, please try it.
https://www.zebra.com/us/en/support-downloads/knowledge-articles/ait/de…
If it doesn't help then could you please share result of following SGD command:
! U1 getvar "allcv"
You can capture SGD command result following the advice in this article:
https://www.zebra.com/us/en/support-downloads/knowledge-articles/printer...
Alexander Palchikov
Software Engineer, Kutir Mobility
Posted on behalf of Zebra Technologies