Hi, Just tested the RhoElements and found out the scanner cannot be enabled. I have alos had a looked at the Usage Note and I really don't understand how to load the scanner driver at device startup? Any idea? MK4000
In order to use the Scanner on the MK4000 it is necessary to preload the scanner drivers at device startup
4 Replies
You need to call start after each successful scan, there's an example in the help file
Hi, Please add the attached exe to your \application\startup folder to preload the drivers Thanks,
Thanks, the scanner beam finally comes up. However, the presentation mode could not work properly... Well, after few seconds the beam turns off and I have to refresh the page to start the scanner again. I am using Any idea?
I would also Like an answer to the presentation scan issue here