I have a customer using an old Cisco configuration which uses WEP with 802.1x/PEAP/MSCHAP-V2. (config inset below). The ET1 discovers this network as a WEP network instead of an 802.1X-PEAP network as as a result we do not get the opportunity to input the credentials and other PEAP parameters. you could input the WEP key Looking around the web I founs that there is a wpa_supplicant.conf file which controls the WI-FI in android, but when I located this file in the /etc/wifi directory on the ET1, it did not reflect the networks which were configured on the ET1. I was able to connect without issue to an 802.1x/PEAP/MSCHAP-V2 network on an RFS6000/AP650 without any issues and that network is configured on the ET1 along with a  seperate WEP network which I can also elect to connect  to as needed Does anyone know where the real configuration file for the WI-FI is on the ET1? Has anyone found a way to disable the auto network discovery so I can simply add the network I want to connect to?
The configuration currently in use it

dot11 ssid AutoAuctions

   vlan 116

   authentication open eap eap_methods

   authentication network-eap eap_methods

   guest-mode

interface dot11Radio 0

encryption vlan 116 mode ciphers tkip wep128

ssid AutoAuctions