I was trying to create a customer guide on how to pair an ET1 with an LS3478 (attached). When I copied barcodes fronm the PDF into the word doc, the images of the barcodes seemed to be fuzzy. I also tried copying the images of the barcodes into paint and then to word, which removed the fuzziness, but were still unreadable. I also tried enlarging the images of the barcodes after copying them into paint..still no luck reading the barcodes.
Any suggestions on how I can copy barcodes from the user guide to a word doc and have them readable would be appreciated
Any suggestions on how I can copy barcodes from the user guide to a word doc and have them readable would be appreciated
Points: 1
You voted ‘up’
Points: 1
You voted ‘up’
Points: 1
You voted ‘up’
Points: 0
You voted ‘up’
I did this in the past and had very good expierience.
Regards Martin Delto
Points: 0
You voted ‘up’
Points: 0
You voted ‘up’
Points: 0
You voted ‘up’
Points: 0
You voted ‘up’
Points: 0
You voted ‘up’
Points: 0
You voted ‘up’
Log in to post comments