After having turn off and on the device that I've updated to BSP 12-02 (non-GMS), seem that the touch screen sensitivity is very hard: getting the system to recognise a touch on the lower four buttons is very tricky.
I've tried to do a factory reset with no changes. Toggling the touch mode from finger to glove made it usable again. Have we changed the sensitivity configuration of the touch?
Looking on the SW Components panel I get:
Touch
Version: STYLUS-78_GLOVE-104,
FW: 1.2.AA
~Pietro
1 Replies
Pietro
i run GA2 12-01 build here and see following settings
default Stylus & Finger Setting under Touch Mode
SW components show:
Version: STYLUS-74_GLOVE-102,
FW: 1.2.AA
dont see Lag of Touch Sensitivity on this build
will update to 12.02 and see how that behaves