New MC3300 Device - Key Programmer won't start error

Hello,

i've a new MC3300 Device and try to program the yellow Buttons. If i start the Key Programmer (Settings -> Key Programmer) i get the following error:

MxFramworkService not running Cannot load KeyProgrammer

What's wrong ?

THX

Christian

I have the same issue.

Has anyone found a fix for this issue yet?

Thanks,

Vote: 
Vote up!
Vote down!

Points: 1

You voted ‘up’


I'm facing this exact issue as well.

Vote: 
Vote up!
Vote down!

Points: 0

You voted ‘up’


I'm having a similar issue on a TC56 running Android 7.1.2.

Vote: 
Vote up!
Vote down!

Points: 0

You voted ‘up’


Hello,

I am also facing this same issue in Zebra TC56

Settings--->Key Programmer --->"MXframework version service not running cannot load key programmer"

It is more helpful when you send your suggestions to resolve this issue.

Regards,

Nadiya

Vote: 
Vote up!
Vote down!

Points: 0

You voted ‘up’


Hello,

This issue has been fixed in latest LG patch. Please use below urls for LG patch(MC3300 Device only).

MC3300 Operating System for GMS Devices Support & Downloads | Zebra

MC3300 Operating System for Non-GMS Devices Support & Downloads | Zebra

Thanks

Vote: 
Vote up!
Vote down!

Points: 1

You voted ‘up’


I have new Zebra TC75FK devices on Android version 7.1.2 - we need to remap keys for scanning using the Key Programmer but getting the following error:
MxFrameworkService not running
Cannot load KeyProgrammer

The Key Programmer works fine on 6.0.1

Vote: 
Vote up!
Vote down!

Points: 0

You voted ‘up’