WT5400s can not customize Barcode Decoder in DataWedge. This prevents us from rolling out a fleet upgrade since it is important we can disable unused decoders.
We've been running our DataWedge code on a large fleet of TC21s, TC8300s, and WT6000s for several years with no issue with enabling/disabling decoders using the SET_CONFIG Intent. This is easily reproducible in Zebra's DataCapture1 sample application.
Steps to Replicate
- Download the DataWedge "DataCapture1" sample project
- Run on a physical WT5400
- Enable only Code39 decoder in the sample app
- Press Set
- Open DataWedge
- Open the "DWDataCapture1" profile
- Press Configure scanner settings
- Press Decoders
Video of steps recorded on a WT5400
Expected Result
Code128, EAN13, and UPCA are disabled and Code39 is enabled in DataWedge.
Actual Result
On WT5400: Code128, EAN13, and UPCA are enabled in DataWedge even though we disabled them in the sample application.
On TC21: Code128, EAN13, and UPCA are disabled as expected.
Environment
Using the steps above we tested this on three different devices with the following results:
❌ WT5400 (Android 13-18-07.00-TG-U00) (DataWedge 13.0.325) (Scanning Framework 42.7.35.0)
✅ TC21 (Android 11) (DataWedge 11.4.505) (Scanning Framework 37.9.38.0)
✅ TC21 (Android 13)
1 Replies
I think this will need a support ticket to be opened with our Support Centre: Contact Support (zebra.com)
Did you try the Showcase app to see if that works (it also uses the Datawedge intent API)? You can download it directly on the WT, select Scanning/Any Barcode , access the settings menu and Enable Additional Symbologies to enable/disable specific decoders. Press the back key to return to the Results screen and check the Datawedge 'Zebra Showcase' profile which should be updated to match the selection made in Settings.