(Bluetooth) Pairing a MT2070 with a PC with the SMDK

Hi,

 

For a developpement I need to pair a MT2000 with a PC for sending files to it, over the bluetooth.

For the first step, I have try the "VB_BluetoothSample1" of the SDMK.

Discovering devices work fine, but when I whant to pair the PC, I automaticly have an error message : "Failure in pairing"

 

For information, I use Visual Studio 2008 and I have try to use the NETCF 2.0 and the 3.5, and also the SMDK 2.6, 2.8 and 2.9 with no success...

 

Do you have any ideas to do this?

 

Regards.

Anonymous (not verified)
Hi,Try disabling Scanner

Hi,

Try disabling Scanner Services as shown below in the MT20xx User Guide - this should allow the BT stack to operate as normal.

Vote: 
Vote up!
Vote down!

Points: 0

You voted ‘up’


Alexandre NICOLADIE
Thanks for your answer.This

Thanks for your answer.

This is the first thing I have done before try pairing, but it did not change anything.

Vote: 
Vote up!
Vote down!

Points: 0

You voted ‘up’


Anonymous (not verified)
Did you cold boot the unit

Did you cold boot the unit after deleting the REG key ?

Vote: 
Vote up!
Vote down!

Points: 0

You voted ‘up’


Alexandre NICOLADIE
Yes, I did it.

Yes, I did it.

Vote: 
Vote up!
Vote down!

Points: 0

You voted ‘up’


Log in to post comments