Dear
I am new to FX9500
I have just configured the reader
I connected zebra AN710 to port 1 ,powered up the FX9500 , logged in and browsed to the Antenna Configuration page
The detected Antenna field is empty
The port number field is of course 4
the configuration field is all_monostatic
I set the mux sequence to 1
submitted >> success but still detected antennas is empty
Checked the reader is in active mode
From the command prompt page Iran the command modem.antennas.perform_check() and got OK
How can i configure the reader to detect the antenna
Note I checked with another zebra Antenna AN 480
0 Replies